|
|
TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
ELECTRICAL DIAGRAM
Step 1.
Disconnect connector from vehicular light switch. Place red probe on pin D.
Place black probe on pin F. Turn vehicular light switch to BO DRIVE. If
multimeter indicates 0 ohms, go to step 2. If multimeter indicates infinity,
replace vehicular light switch. Refer to page 2-566. Turn vehicular light
switch OFF. Connect connector to vehicular light switch.
2-258
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |