|
|
TM 9-2350-238-20-1
Make sure MASTER switch is OFF before repairing electrical
circuits. Failure to observe this warning could result in injury to
personnel.
To access line disconnect, remove transmission deck lid assembly. Refer
Step 2.
to page 2-938. Disconnect lead 19. Place red probe in lead 19. Ground
black probe. Set MASTER switch ON. Turn vehicular light switch to BO
DRIVE. Set BO-IR switch to BO. If multimeter indicates about 24 volts,
repair service headlamp assembly. Refer to page 2-601. If multimeter
indicates no voltage, repair lead 19 between line disconnect and vehicular
light switch. Refer to page 2-371. Set MASTER switch OFF. Turn
vehicular light switch OFF. Connect lead.
2-249
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |