|
|
TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
ELECTRICAL DIAGRAM
Make sure MASTER switch is OFF before repairing electrical
circuits. Failure to observe this warning could result in injury to
personnel.
Remove inoperative blackout marker lamp from service headlamp. Refer to
Step 1.
main light switch and place in blackout drive position. Place blackout-
infrared selector switch in blackout position. Place red probe in socket.
Ground black probe. If multimeter indicates about 24 volts, replace lamp. If
multimeter indicates no voltage, set MASTER switch OFF, install lamp and
go to step 2.
2-236
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |