|
|
TM 9-2350-238-20-1
Make sure MASTER switch is OFF before repairing electrical
circuits. Failure to observe this warning could result in injury to
personnel.
Disconnect instrument (gage) panel wiring harness. Place red probe on pin
Step 3.
N (lead 519). Ground black probe. Set MASTER switch ON. Turn
vehicular light switch to SER DRIVE. Press headlamp dimmer switch for
high beam operation. If multimeter indicates about 24 volts, go to step 5. If
multimeter indicates no voltage, connect wiring harness and go to step 4.
Set MASTER switch OFF. Turn vehicular light switch OFF.
2-225
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |