HI BEAM IND LIGHT CIRCUIT. (Cont) - TM-9-2350-238-20-10250

TM 9-2350-238-20-1

2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).

Step 1.

Remove HI BEAM IND lamp. Refer to page 2-571. Set MASTER switch

ON. Place blackout-infrared selector switch in infrared position and infrared

receiver switch in ON position. Press dimmer switch on floor. Place

instrument switch in ON position. Place red probe in socket. Ground black

probe. If multimeter indicates about 24 volts, replace lamp. If multimeter

indicates no voltage, set MASTER switch OFF, install lamp and go to step

Step 2.

To access electrical leads, remove driver's instrument (gage) panel. Refer

to page 2-571. Disconnect leads 519 from HI BEAM IND light. Place

multimeter probes in leads 519 at light. If multimeter indicates 100 ohms,

go to step 3. If multimeter indicates infinity, replace HI BEAM IND lamp

assembly. Refer to page 2-571.

2-224