|
|
TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
To access electrical leads, open battery compartment access door.
Step 9.
Remove batteries and battery tray. Refer to page 2-640. Disconnect
wiring harness at bulkhead disconnect. Place jumper wire to pin E (lead
506) and ground. Disconnect lead 506 at line disconnect near bulkhead
disconnect (aft side). Place red probe in lead 506. Ground black probe.
If multimeter indicates continuity, go to step 10. If multimeter indicates
infinity, repair lead 506 between bulkhead disconnect and line disconnect.
Refer to page 2-371. Remove jumper wire. Connect wiring harness.
Connect line disconnect.
2-182
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |