GENERATOR WARNING LIGHT CIRCUIT. (Cont)

TM 9-2350-238-20-1

Make sure MASTER switch is OFF before repairing

electrical circuits. Failure to observe this warning

could result in injury to personnel.

Step 8.

Disconnect wiring harness. Place red probe in plug socket L (lead 506).

Ground black probe. Set MASTER and INST switches ON. If multimeter

indicates about 24 volts, repair lead 506 between receptacle and line

disconnect behind driver's instrument (switch) panel. Refer to page 2-371.

If multimeter indicates no voltage, go to step 9. Connect wiring harness.

Set MASTER and INST switches OFF.

2-181