|
|
TM 9-2350-238-20-1
Make sure MASTER switch is OFF before repairing
electrical circuits. Failure to observe this warning
could result in injury to personnel.
Disconnect wiring harness from master relay. Place red probe on master
Step 5.
relay receptacle pin (lead 81) and ground black probe. Set MASTER
switch ON. If multimeter indicates no voltage, replace master relay. Refer
to page 2-584. If multimeter indicates about 24 volts, go to step 6. Set
MASTER switch OFF. Connect wiring harness to master relay.
2-105
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |