 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2330-202-14&P
b.
CLEANING AND INSPECTION
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective
goggles and gloves, and use only in a well-ventilated area. Avoid contact
with skin, eyes, and clothes, and DO NOT breathe vapors. DO NOT use near
open flame or excessive heat.
1.
Use wire brush to remove all corrosion.
2.
Clean all components with drycleaning solvent and rag and allow to dry.
3.
Touch up paint (refer to TM 43-0139).
4.
Use lubricating oil to coat mating surfaces of drawbars, drawbar ring, and drawbar bracket assembly.
5.
Inspect all components for wear, cracks, broken welds, and other damage. Replace if damaged.
c.
INSTALLATION
1.
Install drawbar bracket assembly (18), four capscrews (17), and new self-locking nuts (16).
2.
Install safety chains (15 and 14), capscrew (13), and new self-locking nut (12).
3.
Install bracket (11), bolt (10), and new self-locking nut (9).
4.
Install support leg (8), two capscrews (7), and new self-locking nuts (6).
5.
Install drawbar ring (5), nut (4), and new cotter pin (3).
6.
Raise trailer with jack and remove jackstands (1) from drawbars (2). Lower trailer to ground.
438-016
FOLLOW-ON TASKS:
None.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals