CLEANING AND INSPECTION - TM-9-2330-202-14-P0170

TM 9-2330-202-14&P

4-39.

MASTER CYLINDER REPLACEMENT (continued).

NOTE

The boot may be inside hydraulic brake acuator assembly.

Remove boot (8) from master cylinder (3) or from inside hydraulic brake actuator assembly (9).

Remove fluid passage bolt (10), washer (11), connector (2), and washer (12) from master cylinder (3).

NOTE

For trailers with master cylinder cap, do step 5. For trailers with drain hose, do step 6.

Remove cap (13) and gasket (14) from master cylinder (3). Discard gasket If damaged.

Loosen clamp (15) and remove drain hose (16) from vent tube (17).

Remove vent tube (17), filler cap (18), baffle (19), and gasket (20) from master cylinder (3). Discard gasket if

damaged.

CLEANING AND INSPECTION

WARNING

Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles and

gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes, and

DO NOT breathe vapors. DO NOT use near open flame or excessive heat.

1. Clean all removed components except boot with drycleaning solvent and allow to dry. Clean boot with detergent and

water.

4-74