|
|
TM 9-2330-202-14&P
4-35.
SERVICE BRAKE MAINTENANCE (continued).
2.
Inspect backing plate for cracks, breaks, corrosion, or other damage. Replace backing plate if damaged.
WARNING
If one brakeshoe is being replaced, replace all brakeshoes on axle. Combination of old
brakeshoes with new brakeshoes will cause uneven braking. Accidents causing serious injury or
death to personnel or damage to equipment may result.
3.
Inspect brakeshoe linings for cracks or grease. Measure lining thickness. Lining thickness must be at least 1/8 inch
(3.18 mm). Replace brakeshoes if damaged, grease soaked, or worn.
4.
Inspect strut and lever for cracks and wear. Replace if damaged.
5.
Inspect adjusting screw for corrosion or wear on teeth. Replace adjusting screw if corroded or worn.
6.
Inspect wheel cylinder for leakage and corrosion. Replace if damaged.
7.
Inspect all other removed components for cracks, breaks, distortion, corrosion, or other damage. Replace any
damaged components.
d.
ASSEMBLY
1.
Install wheel cylinder (29) on backing plate (6) with new
lockwasher (28) and bolt (27). Torque bolt between 130 and
230 lb-in (15-26 N-m).
2.
Install lever (4) on brakeshoe (15) with spring tension washer
(26) and new clamp (25). Pinch ends of clamp (25) to retain it
securely in place.
4-58
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |