Section II. SERVICE UPON RECEIPT - TM-9-2330-202-14-P0082

TM 9-2330-202-14&P

Section II. SERVICE UPON RECEIPT

Paragraph

Page

Number

Paragraph Title

Number

4-5

General............................................................................................................................................... 4-2

4-6

Inspection Instructions........................................................................................................................ 4-2

4-7

Servicing Instructions ......................................................................................................................... 4-2

4-5.

GENERAL.

When a new, used, or reconditioned trailer is received, determine whether it has been properly prepared for service and is

capable of performing Its mission by following the inspection instructions in paragraph 4-6 and the servicing instructions in

paragraph 4-7.

4-6.

INSPECTION INSTRUCTIONS.

Refer to DD Form 1397 for procedures on unpacking the trailer.

Remove all straps, plywood, tape, seals, and wrappings.

WARNING

Drycleaning solvent P-D-680 is toxic and flammable. Always wear

protective goggles and gloves, and use only in a well-ventilated

area. Avoid contact with skin, eyes, and clothes, and DO NOT

breathe vapors. DO NOT use near open flame or excessive heat.

Remove rust preventive compound from coated exterior parts of the trailer using drycleaning solvent (Item 15,

Appendix F) and a clean rag (Item 13, Appendix F).

Inspect the trailer for damage incurred during shipment. Check also to see if the equipment has been modified.

Check the equipment against the packing list to see if shipment is complete.

Report any discrepancies in

accordance with Instructions in DA Pam 750-8.

4-7.

SERVICING INSTRUCTIONS.

Perform all Operator/Crew and Unit preventive maintenance checks and services (PMCS) listed in Tables 2-1 and

4-1. Schedule the next Unit PMCS on DD Form 314.

Lubricate all lubrication points as described in Appendix I, regardless of interval.

If any system of the trailer does not operate properly, refer to the troubleshooting instructions in Chapter 3, Section

I (Operator/Crew), or Chapter 4, Section IV (Unit).

Perform a break-in road test of 25 miles (40 km) at a maximum speed of 50 miles per hour (80 kph).

Report all problems on DA Form 2407.

4-2