 |
|||
|
|
|||
|
Page Title:
ALTERNATE FIFTH WHEEL MOUNTING POSITION (FOR NON-M1000 TRAILERS) |
|
||
| ||||||||||
|
|
 TM 9-2320-360-20-2
14-6. ALTERNATE FIFTH WHEEL MOUNTING POSITION (FOR NON-M1000 TRAILERS)
This task covers:
a. Alignment (Front to Rear)
c. Follow-On Maintenance
b. Alignment (Rear to Front)
INITIAL SETUP
Equipment Conditions
Materials/Parts
Fifth wheel ramp extensions removed
Locknuts (30) (Item 63, Appendix G)
Locknuts (8) (Item 62, Appendix G)
Tool and Special Tools
Tool Kit, Genl Mech (Item 54, Appendix F)
Wrench, Torque, 0-600 Lb-Ft (Item 74,
a. Alignment (Front to Rear)
WARNING
Fifth wheel plate must be secure
before
performing
maintenance.
Failure to do so may result In Injury
to personnel.
NOTE
The HET Tractor can haul a variety of
trailers by moving the fifth wheel
forward and rearward on the frame.
This task covers aligning the fifth
wheel to accept trailers other than
the M1000 trailer (front to rear) and
returning it to its normal position
(rear to front).
(1) Block fifth wheel (1) in a horizontal
position.
(2) Remove 12 locknuts (2), screws (3), and
two rear lifting lugs (4) from frame rails (5).
Discard locknuts.
(3) Position rear lifting lugs (4) two holes
toward rear of HET Tractor.
(4) Install 2 rear lifting lugs (4) on frame (5)
with 12 screws (3) and new locknuts (2).
Torque to 375 lb-ft (509 Nm).
(5) Install angle stop (6) on fifth wheel ramps
(7) with eight screws (8) and new locknuts
(9).
Torque to 167 lb-ft (227 Nm).
14-15
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
