Follow-On Maintenance - TM-9-2320-360-20-20885

TM 9-2320-360-20-2

13-7. REAR STEERING SHAFTS NO. 1, NO. 2, NO. 3, NO. 4, AND NO. 5 REPAIR (CONT)

(20) Install yoke (25) from steering shaft no. 5 on

gear reducer (1.2) with screw (27) and new

locknut (28). Torque to 35-40 lb-ft (48-54 N m).

CAUTION

To install screws, holes in steering

shafts must align with grooves in

steering gear shafts.

Failure to

install screws through grooves may

result

steering

shafts

disconnecting, causing damage to

equipment.

(21) Install yoke (29) from steering shaft no. 5 (0.3)

on steering gear (30) with screw (31) and new

locknut (32). Torque to 35-40 Ib-fl (48-54 N m).

g. Follow-On Maintenance

(1) Lube steering shafts (LO 9-2320-360-12).

(2) Start engine (TM 9-2320-360-10).

(3) Check operation of steering (TM 9-2320-360-10).

(4) Shut off engine (TM 9-2320-360-10).

13-34