 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-20-2
11-30. AIR GOVERNOR TESTING/ADJUSTMENT (CONT)
b. Adjustment
(1) Shut off engine (TM 9-2320-360-10).
(2) Unscrew cap (1) from air governor (2).
(3) Loosen nut (3) at base of adjusting screw
(4).
NOTE
One complete turn will change
adjustment approximately 15 psi (103
kPa).
(4) Turn adjusting screw (4) in to decrease
cutout air pressure or out to increase
cutout air pressure.
(5) Hold adjusting screw (4) and tighten nut
(3).
(6) Press and release brake pedal to reduce
air pressure reading on gage to below 100
psi (690 kPa).
(7) Start engine (TM 9-2320-360-10).
(8) Observe pressure at which governor (2)
cuts out. Repeat steps (1) thru (6) if
governor does not cut out at 120-125 psi
(827-862 kPa).
(9) Shut off engine (TM 9-2320-360-10).
(10) Install cap (1) on air governor (2).
c. Follow-On Maintenance
Install lower engine access panel (para 16-2).
11-118
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
