 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-20-2
11-4.2. SLACK ADJUSTER (AUTOMATIC - AXLES NO. 2, 3 & 4) REPL (CONT)
(8) Remove cotter pin (8) and pin (9) from
slack adjuster (10). Discard cotter pin.
(9) Remove cotter pin (11) and pin (12) from
slack adjuster (10) and clevis (13) on
brake chamber (4). Discard cotter pin.
CAUTION
The pawl must be pulled out when
rotating the manual adjusting nut.
Failure to comply will result in
damage to slack adjuster.
(10) Pull pawl (14) out while turning adjusting
screw
(15)
counterclockwise
one
revolution.
WARNING
Wear eye protection and use care
when removing snap rings. Snap
rings are under spring tension and
can act as projectiles when released
and may cause severe eye Injury.
NOTE
Axles no. 2 and no. 3 do not
have a snap ring between axle
housing and washer.
The number and thickness of
washers will vary. For proper
assembly, tag and mark shims
during removal.
(11) Remove snap ring (16), washer (17), slack
adjuster (10), washer (18), and snap ring
(19) from brake camshaft (20).
Change 3 11-10.7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
