2320-01-318-9902 EIC:B5C, VOLUME NO. 2">
|
|
TM 9-2320-360-20-2
c. Installation
WARNING
Wear eye protection and use care when
removing snap rings. Snap rings are
under spring tension and can act as
projectiles when released and may
cause severe eye Injury.
NOTE
Install slack adjuster so that
adjusting nut faces away from
brake chamber.
Washers should be installed in
locations marked during removal.
(1) Install snap ring (1), washer(s) (2), slack
adjuster (3), washer(s) (4), and snap ring (5)
on brake camshaft (6).
(2) Turn adjusting screw (7) clockwise until
holes in clevis (8) and slack adjuster (3) are
aligned.
(3) Install pin (9) through clevis (8) and slack
adjuster (3).
(4) Install new cotter pin (10) in pin (9).
(5) Install pin (11) through clevis (8) and slack
adjuster (3).
(6) Install new cotter pin (12) in pin (11).
d. Follow-On Maintenance
(1) Grease slack adjuster (LO 9-2320-360-12).
(2) Adjust brakes (para 11-2.1).
Change 3 11-10.5
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |