 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-20-2
WARNING
Wear eye protection and use care
when removing snap rings. Snap
rings are under spring tension and
can act as projectiles when released
and may cause severe eye injury.
NOTE
The number and thickness of
washers will vary.
For proper
assembly, tag and mark shims during
removal.
(4) Remove snap ring (9), washer(s) (10),
slack adjuster (3), washer(s) (11), and
snap ring (12) from brake camshaft (13).
b. Placing in Service
WARNING
Brake chamber clevis position must
be checked as described below. If
the clevis position is not correct, the
slack adjuster will not adjust the
brakes correctly. If the slack adjuster
under-adjusts, the vehicle stopping
distances will be Increased. If the
slack adjuster over-adjusts, the brake
linings may drag resulting In
excessive wear.
(1) Install large clevis pin (1) thru hole (2) in
clevis (3).
(2) Install installation guide (4) over the brake
camshaft (5).
(3) Swing the installation guide (4) into clevis
(3) until slot totally engages large clevis
pin (1).
(4) Look thru small hole (6) of clevis (3).
Small hole of installation guide (4) must be
completely visible thru the hole in clevis
(3).
Change 3 11-10.3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
