 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-20-2
7-94. GENERAL WIRE HARNESS REPAIR (CONT)
f. Type 6 Connector Repair
(1) Slide outer shell (1) back on wire (2).
(2) Remove C-washer (3) from wire (2).
(3) Cut terminal (4) from wire (2).
(4) Trim end of wire (2) as needed.
(5) Remove 0.38 in. (1.0 cm) of insulation (5)
from end of wire (2).
(6) Install terminal (4) on wire (2).
(7) Install C-washer (3) on wire (2) just below
terminal (4).
(8) Slide outer shell (1) over C-washer (3) and
terminal (4).
(9) Inspect outer shell (1) to ensure no bare
wire is visible.
g. Type 7 Connector Repair
(1) Slide outer shell (1) and sleeve (2) back
on wire (3).
(2) Remove contact (4) from wire (3).
(3) Trim end of wire (3) as needed.
(4) Remove 0.25 in (0.635 cm) of insulation
(5) from end of wire (3).
(5) Install sleeve (2) over end of wire (3).
(6) Install contact (4) over end of wire (3).
Crimp contact (4).
(7) Slide outer shell (1) over wire (3).
(8) Inspect outer shell (1) to ensure no bare
wire is visible.
7-286
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
