2320-01-318-9902 EIC:B5C, VOLUME NO. 2">
|
|
TM 9-2320-360-20-2
7-60. 7-PIN ELECTRICAL CONNECTOR REPLACEMENT (CONT)
NOTE
Wires should be installed in positions
noted in Table 7-2 or Table 7-3.
(10) Install wires (2) in electrical connector (5).
(11) Install electrical connector (5) on mounting
bracket (6) with two screws (7) and new
locknuts (8).
NOTE
Wires should be installed in positions
noted in table 7-2 or table 7-3.
(12) Install wires (9) on electrical connector
(10).
(13) Tighten screws
(11)
on
electrical
connector (10).
(14) Install electrical connector
(10)
on
mounting bracket (6).
(15) Install two screws (7) and new locknuts (8)
on electrical connector (10).
WARNING
On direct contact, uncured silicone
sealant irritates eyes.
In case of
contact, flush eyes with water and
seek medical attention. In case of
skin contact, wipe off and wash with
water.
(16) Apply thin strip of silicone adhesive-
sealant around electrical connector (10).
(17) Install rubber collar (12) on electrical
connector (10).
(18) Apply thin strip of silicone adhesive-
sealant around rear of rubber collar (12)
where wires (9) enter.
7-182 Change 2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |