Follow-On Maintenance - TM-9-2320-360-20-20384

TM 9-2320-360-20-2

NOTE

Route two wires no. 150 under hold

down bracket.

(10) Install cable (47) and two wires no. 150

(48) on negative (-) terminal (49) with

screw (50), two washers (51), new

lockwasher (52), and nut (53). Torque to

144-192 lb-in. (16.1-21.5 Nm).

(11) Install cables (47 and 54) and wire no.

1813 (55) on negative (-) terminal (56)

with screw (57), two washers (58), new

lockwasher (59), and nut (60). Torque to

144-192 lb-in. (16.1-21.5 Nm).

(12) Install two negative (-) terminals (49 and

56) on battery posts (61 and 62).

(13) Tighten nuts (63 thru 70) to 84-96 lb-in.

(9.4-10.8 Nm).

(14) Lightly coat all battery posts and terminals

with anticorrosion grease.

J. Follow-On Maintenance

(1) Install accessory air supply coupling (para 11-41).

(2) Install no. 3 air reservoir (para 11-21).

(3) Install no. 4 air reservoir (para 11-22).

(4) Connect arctic kit batteries if installed (para 19-2).

(5) Start engine to check operation of batteries (TM 9-2320-360-10).

(6) Shut off engine (TM 9-2320-360-10).

(7) Install battery box cover (TM 9-2320-360-10).

(8) Remove wheel chocks.

Change 1 7-171