Installation - TM-9-2320-360-20-20228

TM 9-2320-360-20-2

7-9. STARTER REPLACEMENT (CONT)

c. Installation

WARNING

Adhesive-sealant can burn easily,

can give off harmful vapors, and is

harmful to skin and clothing. To

avoid injury or death, keep away from

open fire and use in well ventilated

area. If adhesive sealant gets on skin

or clothing, wash immediately with

soap and water.

(1) Coat new gasket (1) with adhesive-sealant.

(2) Install new gasket (1) on starter (2).

(3) Position starter (2) on ground under engine

compartment.

(4) Position suitable lifting device around starter (2).

WARNING

Starter weighs 72 lb (33 kg) and is

difficult to handle. To prevent injury,

use caution when removing.

(5) Lift starter (2) into engine compartment and

position starter in flywheel housing (3) with aid of

assistant.

(6) Position three new lockwashers (4) and screws

(5) in flywheel housing (3) and starter (2). Do

not tighten.

(7) Remove lifting device from starter (2).

(8) Install electrical connector (6) on STE/ICE oil

temperature sensor (7).

(9) Tighten three screws (5) to 137-147 lb-ft (186-

200 Nm) using torque wrench (8).

(10) Install wire no. 1045 (9) and wire no. 1816 (10)

on terminal (11) with new lockwasher (12) and

nut (13).

STEERING COLUMN

REMOVED FOR CLARITY

7-28