 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-20-2
CAUTION
Clamp must be positioned next to
bead on crossover tube.
Do not
position clamps over bead. Failure to
comply may result in coolant leak
and damage to equipment.
NOTE
When clamp is properly tightened,
washer stacks should be nearly
collapsed flat and screw tip should
extend beyond clamp approximately
3/16 in. (8 mm).
(13) Slide hose (25) on cover (4). Torque
clamps (26) to 90 lb-in. (10.3 Nm).
(14) Slide hose (27) on water pump (28).
Tighten clamps (29).
(15) Install two hoses (30) and four clamps
(31) on radiator (32) and thermostat cover
(3 or 4). Torque to 100 lb-in. (11 Nm).
(16) Install exhaust tube (33) on turbocharger
(34) and exhaust manifold (35) with two
new clamps (36).
(17) Install two new locknuts (37) on clamps
(36).
NOTE
Plastic cable tie should be positioned
in location marked during removal.
(18) Secure wire harness (38) to hose (30) with
plastic cable tie (39).
d. Follow-On Maintenance
(1) Install ECM (para 7-29 or para 7-29.1).
(2) Fill cooling system (para 6-2).
Change 3 6-33
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
