 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-285-24-2
4-4.
TRANSMISSION (CONT)
k. Governor and Rear Cover Assembly (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
INSPECTION
9
a. Roller bearing
Inspect
Inspect for wear, chipping, or
(15), outer
nicks. Inspect for roughness
race (29),
or binding in operation. Re-
ball bearing
place if necessary. If de-
(23), and
fects are found in either
needle bearing
roller bearing (15) or outer
(17)
race (29), replace both as a
matched set. After inspec-
tion, dip bearings in clean,
light machine oil and wrap
in clean, lintless cloth for
protection until installed
b. Shaft (8)
Inspect
Inspect splines for wear, pit-
ting, nicks, cracks or
scores. Remove small nicks
with suitable sharpening
stone. Inspect shaft for
bent, sprung, or twisted
condition; replace if neces-
sary
c.
All other parts
Inspect
Inspect for worn, cracked,
bent or broken condition. If
any of these conditions are
noted, replace part
REASSEMBLY
10
Governor
Two new governor
Install
Follow directions in governor
assembly
weight pins (33)
service kit for reassembly
(5)
of governor assembly
11
Cover (19)
a. Plug (24)
Install
Tight enough to prevent leaks
b. Plug (25)
Install
Tight enough to prevent leaks
c. New plug (32)
Install
If old plug (32) was removed.
Tighten enough to prevent
leaks
d. New governor
Install
Open end first
filter (27)
e. New O-ring
Install
seal (28)
f. Plug (26)
Install
Tight enough to prevent leaks
4-127
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals