REASSEMBLY - TM-9-2320-285-24-20567

TM 9-2320-285-24-2

4-4. TRANSMISSION (CONT)

g. Low Planetary, Low Clutch, and Adapter Housing Assemblies (cont).

STEP

LOCATION

ITEM

ACTION

REMARKS

(cont)

CAUTION

In following step, don 't put any pressure on carrier and bushing assembly (19), or you will distort it.

Six pins (21)

Install. Install removing, installing and swaging fixture onto

arbor press. Install carrier and bushing assembly (19)

onto fixture. Install pin installer into fixture, so that

cutaway part will clear bosses of carrier and bushing

assembly (19) when pins (21) are pressed in. One at a

time, place pins (21) on pilot ends of 5/8 guide pins.

Press into carrier and bushing assembly (19) until pin

installer touches carrier and bushing assembly

Swage. Remove carrier and bushing assembly (19) from

Six pins (21)

removing, installing and swaging fixture. Install bottom

swaging tool holder into fixture. Install one swaging tool

into bottom swaging tool holder and one into fixture.

Lubricate both ends of pins (21) with oil-soluble grease.

Position carrier and bushing assembly (19) rear end up on

fixture. Use support block to level carrier and bushing

assembly while lower swaging tool is supporting lower end

of pin (21). One pin at a time, apply pressure gradually

(about three tons) to swage ends of pins against carrier

and bushing assembly (19), as shown. Pinion set (24)

must rotate freely and have end play of 0.008 to 0.031

inch. Remove carrier and bushing assembly (19) from

fixture.

Remove bottom swaging tool holder and

removing, installing and swaging fixture from arbor press

4-86