 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-285-24-2
4-4. TRANSMISSION (CONT)
g. Low Planetary, Low Clutch, and Adapter Housing Assemblies (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
CLEANING (cont)
13
b.
Adapter housing
Clean
Wipe with clean cloths mois-
(cont)
(9)
tened with cleaning solvent
P-D-680. Remove all dirt and
old lubricant. Dry thorough-
ly with compressed air or
with clean, dry, lintless
cloths
INSPECTION
14
a.
Carrier
Inspect
Inspect for worn, overheated,
assembly (3)
or contaminated condition.
Inspect rollers (25) for
roughness and binding in
operation. Check end play of
pinion set (24) by inserting
thickness gage between car-
rier and bushing assembly
(19) and thrust washers
(22). End play must be 0.008
to 0.031 inch. Inspect bush-
ing (20) for galling and
scratches. If you notice any
defective conditions, re-
place part. Replace entire
pinion set (24) if any indi-
vidual pinion is damaged.
Refer to step 10
b.
Gear (1) and
Inspect
Inspect for cracks, dis-
low sun
tortion, and wear. Inspect
gear (5)
teeth and splines for wear,
pitting, nicks, cracks or
scores. Remove small nicks
with suitable sharpening
stone.
Replace if
necessary
c.
Adapter housing
Inspect
Inspect for cracks, dis-
(9)
tortion, and wear. Inspect
gasket surfaces for scratch-
es, other wear. Replace if
necessary
d.
Piston release
Inspect
Replace if broken, bent, or
springs (14
permanently set
and 28)
4-84
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals