CLEANING (cont) - TM-9-2320-285-24-20545

TM 9-2320-285-24-2

4-4. TRANSMISSION (CONT)

e. Third Clutch, Center Support, and Second Clutch Assemblies (cont).

STEP

LOCATION

ITEM

ACTION

REMARKS

CLEANING (cont)

WARNING

Compressed air must not exceed 30 psi. Wear safety glasses when drying parts with compressed air. Failure to do

so could cause serious injury to eyes and possible blindness. If you hurt your eyes or if a foreign object is blown into

your eyes, seek medical attention immediately.

All parts

Clean

Use cleaning solvent P-D-680.

Immerse parts in solvent and

move up and down to remove

all dirt and old lubricant.

Dry thoroughly with com-

pressed air or with clean,

dry, lintless cloths

INSPECTION

Bushing (29)

Inspect

Inspect for scoring, galling,

other wear. Replace if nec-

essary. See step 4b

Pistons (16 and

Inspect

Inspect for worn, bent, or

17) and

broken condition, especially

attached parts

projections on pistons (16

and 17). If you notice any

of these conditions, replace

part. See steps 3c-e

All other parts

Inspect

Inspect for worn, bent, or

broken condition. If you

notice any of these condi-

tions, replace part

REASSEMBLY

Support (8)

New check ball

Install

If old check ball (30) was

(30)

removed

4-64