REMOVAL (cont) - TM-9-2320-285-24-20544

TM 9-2320-285-24-2

4-4. TRANSMISSION (CONT)

e. Third Clutch, Center Support, and Second Clutch Assemblies (cont).

STEP

LOCATION

ITEM

ACTION

REMARKS

REMOVAL (cont)

Four rings (20)

Remove

Only if inspection shows

(cont)

piston (16) or attached

parts must be replaced. Cut

rings (20) off with diagonal

cutting pliers to prevent

damage to piston projections

Spring retainer Remove

ring (21)

20 piston re-

Remove

turn springs

(22)

NOTE

Repeat step 3 for piston (17), lip type seal rings (23 and 24), four rings (25), ring (26), and 20 piston return springs

(27).

Bushing

a. Two seal rings

Remove

Discard

and center

(9)

support

b. Bushing (29)

Remove

Only if inspection shows re-

(28)

placement is necessary.

Mark location of bushing

notch in relation to sup-

port (8). Press out

Check ball (30)

Remove

CLEANING

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and gloves and

use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and don't breathe vapors. Do not use

near open flame or excessive heat and don't smoke when using it. Failure to do so could cause serious injury. If

you become dizzy while using cleaning solvent, get fresh air immediately, and get medical attention. If contact with

skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water

immediately, and obtain medical aid immediately.

4-63