 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-285-24-2
4-3.
TORQUE CONVERTER (CONT)
STEP
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (cont)
release
Place pencil line,
as shown, in cover assembly
28
Cover
a
Piston (7)
Install
Piston (7) must engage guide pins in
cover assembly (3) or lockup
clutch will not RELEASE. Place
pencil line, as shown, in cover
assembly in line with pin nearest
assembly hole in piston (7)
when
balance marks
line up. Use pencil mark as
guide to line up piston (7) with
pin. If piston is seated properly,
distance from cover assembly
mounting surface to piston is
about 1-1/2 inches
TA236043
b
Snap ring (9)
Install
With hand, push down on
piston (7)
c
Bearing race
Install
Inner lip first in hub
Retain
(8)
with oil-soluble grease
29
Converter
a
Cover assembly
Position
Aline balance marks on cover
pump
(3)
assembly (3), plate (16),
assembly
and converter pump
assembly
(14)
(14)
b
24 locknuts
Install
Tighten to 19-23 pounds foot
(6)
30
Cover
a
Spacers (5)
Install
Onto cover assembly drive
assembly
studs
(3)
b
Spacer retain-
Install
ers (4)
4-16
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals