 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-285-24-2
3-42.
FIFTH WHEEL HYDRAULIC SYSTEM MAINTENANCE (CONT)
b. Power Take-off (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (cont)
19
c.
Four capscrews
Install and
(cont)
(53)
tighten
d.
New gaskets (51)
Position
Initially use two 0.020 inch
gaskets; use more as needed
e.
Open end bearing
Position
Offset of bearing cap
cap (50)
opposite input gear (45)
f.
Four socket head
Install and
screws (49)
tighten
g.
Dial indicator
Position
On housing (68)
h.
Output shaft
Check
Check that shaft turns freely
(60)
and that end play does not
exceed 0.006 inch
i.
Dial indicator
Remove
j.
Oil seal (52)
Install
Use suitable sleeve and
hammer to seat fully
20
Drive gear
a.
Input gear (45)
Lay flat
(44)
b.
Drive gear (44)
Position
On top of input gear (45)
c.
One needle
Install
roller (46)
d.
Spacer (47)
Install
e.
One needle
Install
roller (46)
f.
Idler shaft
a. Position
In housing (68), with set-
(41)
screw (40) side down
b. Install
In housing (68), until idler
shaft breaks through inside
wall of housing
NOTE
Groove in idler shaft (41) must align with setscrew hole in housing (68).
g.
Thrust washer
Position
In housing (68), to align
(43)
with idler shaft (41) hole
h.
Gear assembly
Install
In housing (68)
i.
Idler shaft (41)
Install
Use soft hammer to tap in
j.
Thrust washer
Install
(42)
3-430
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals