|
|
TM 9-2320-285-24-1
2-73.
HEATERS MAINTENANCE (CONT)
c.
Battery Warmers.
This task covers:
a. Removal
c.
Inspection
b. Cleaning
f.
Installation/Adjustment
INITIAL SETUP:
Tools
Equipment Condition
No. 1 Common Organizational Maintenance
Paragraph
Condition Description
Tool Kit
Slip joint pliers
Vehicle parked on level
Tool kit, electrical connector
surface, engine off, and
Wire stripper
parking brake applied.
Winterization system cable
Materials/Parts
disconnected from junction box.
Clean cloths
Item 2, Appendix C
2-34b
Battery box lid raised and
Detergent
Item 27, Appendix C
supported.
Electrical tape
Item 37, Appendix C
2-34a
Battery ground cable and
10 tie straps
FSCM 96906 PN MS3667-2-9
positive cable disconnected;
negative and positive lugs
Personnel Required
removed (wires and cables
Wheel Vehicle Mechanic MOS 63B
still attached); hold-down
brackets removed.
2-63c
Spare tire mount lowered.
STEP
LOCATION
ITEM
ACTION
REMARKS
REMOVAL
WARNING
Battery warmers operate from 110 Vac commercial power source.
Disconnect winterization system cable from receptacle at front bumper of
tractor before proceeding. Serious injury or death can result from contact
with energized 110 Vac power lines.
Battery box lid is heavy. Secure lid in open position to prevent injury from
falling lid. If you are injured, seek medical aid immediately.
1
Right hand
a. Electrical tape
Remove
From plastic tubing (2 and 3)
frame rail,
b. Four tie straps
Cut and
Discard tie straps (1)
behind
(1)
remove
battery
c. Plastic tubing
Remove
Pull open at slits and remove
box
(2 and 3)
from wire nuts (4), 3-wire
cords (6 and 7), and
battery end of 3-wire cord
(5)
d. Electrical tape
Remove
From wire nuts (4)
e. Three wire nuts
Remove
(4)
2-825
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |