REMOVAL - TM-9-2320-285-24-10768

TM 9-2320-285-24-1

2-65. BODY AND CAB MAINTENANCE (CONT)

k. Cab Pivot Pins and Bushings (cont).

STEP

LOCATION

ITEM

ACTION

REMARKS

REMOVAL

Right side

a. Cab hydraulic

Raise cab

Approximately one foot

of vehicle

pump

and deck

b. Wood blocks

Position

Under cab deck on frame rail

(both sides of frame) next

to hydraulic locks

c. Cab hydraulic

Lower cab onto

pump

wood blocks

Front of

a. Chain hoist

Attach to

Near deck pivot points. Take

vehicle,

deck

up chain slack

under cab

b. Two lubrication

Remove

deck

fittings (1)

c. Two locknuts

Remove

(2) and

washers (3)

WARNING

Be sure chain hoist is securely fastened to cab deck before performing the following step. Failure to do so

could cause serious injury or death due to cab deck falling on you. If you are injured by falling equipment,

obtain medical aid immediately.

d. Two pivot pins

Remove

Use brass hammer and drift

(4)

if necessary

e. Cab and deck

Raise

Approximately three inches,

just enough to enable

removal of two rubber

mounts (5)

f. Wood blocks

Install

Under cab deck to support

deck

WARNING

Be sure cab and deck are securely blocked before performing the following step. Failure to do so could

cause death or serious injury due to cab and deck falling on you. If you are injured by falling equipment,

obtain medical aid immediately.

g. Two rubber

Remove and

Use 1-15/16 inches diameter

mounts (5)

discard

sleeve or rod; remove from

inside outward

2-745