REMOVAL (cont) - TM-9-2320-285-24-10734

TM 9-2320-285-24-1

2-65.

BODY AND CAB MAINTENANCE (CONT)

Rear Cab Guard and Heat Shield (cont).

STEP

LOCATION

ITEM

ACTION

REMARKS

REMOVAL (cont)

Rear cab

a. Four locknuts

Remove

guard (5),

(1) and wash-

left side

ers (2)

b. Two capscrews

Remove

(3) and two

capscrews (4)

c. Rear cab guard

Remove

Lift using chain hoist

(5)

NOTE

Shims (6, 7, 8, and 9) will fall on ground when rear cab guard (5) is pulled from frame rails.

Cab tilt

Cab

Tilt 45

pump

degrees

Frame, left

a. Two nuts (10),

Remove

Support heat shield (13)

side, near

capscrews

exhaust

(11), and

manifold

lock washers

(12)

b. Heat shield

Remove

(13)

CLEANING

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective

goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and

clothes and don't breathe vapors. Do not use near open flame or excessive heat and don't

smoke when using it. Failure to do so could cause serious injury. If you become dizzy while

using cleaning solvent, get fresh air and medical attention immediately. If contact with skin or

clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes

with water and seek medical aid immediately.

2-711