|
|
TM 9-2320-285-24-1
2-58. STEERING SYSTEM MAINTENANCE (CONT)
b.
Hydraulic Steering Lines and Fittings (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REPAIR (CONT)
13
Connector (16)
Clean
Use cleaning solvent P-D-680;
and/or elbow
allow to air dry. Use wire
(1, 27, or
brush to remove all hose
30)
residue from socket and/or
nipple of connector or
elbows
14
Hose (2 or
a. Hose (2 or 31)
Cut to proper
Use new hose; use old hose
31)
length
for determining proper
length required. Cut hose
square using fine tooth
hacksaw
b. Connector (16)
Place connector socket in vise as shown
c. Hose (2)
Screw hose counterclockwise into socket
until hose bottoms; back hose off
1/4 to 1/2 turn
d. Mandrel assem-
Oil nipple threads, mandrel assembly tool,
bly tool
and inside of hose liberally using hydrau-
lic oil. Tighten connector nipple and nut
on mandrel assembly tool. Apply oil to all
parts
e. Connector (16)
Screw nipple clockwise into socket and
hose. Allow 1/32 to 1/16 inch clearance
between nut and socket so nut will
swivel. Remove mandrel assembly tool from
connector. Remove connector from vise
15
Hose (2 or
a. Hose (2 or 31)
Cut to proper
Use new hose; use old hose
31)
length
for determining length
required. Cut hose square
using fine tooth hacksaw
b. Elbow (1, 27,
Place elbow socket in vise
or 30)
c. Hose (2 or 31
Screw hose counterclockwise into socket
until hose bottoms; back off hose 1/4 to
1/2 turn
2-662
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |