INSPECTION (cont) - TM-9-2320-285-24-10684

TM 9-2320-285-24-1

2-58. STEERING SYSTEM MAINTENANCE (CONT)

Hydraulic Steering Lines and Fittings (cont).

STEP

LOCATION

ITEM

ACTION

REMARKS

INSPECTION (cont)

e. Clamps (5, 8,

Inspect for:

Replace as necessary

(cont)

11, and 15)

damage

cracks

f. Clamps (17, 18,

Inspect for:

Replace if any defects are

25, and 26)

damage

observed

cracks

deformed

threads

REPAIR

WARNING

If connector (16) and/or elbows (1, 27, and 30) require replacement, discard hose (2 or 31). If hose is

reused, hydraulic oil leakage could occur causing loss of steering control. This in turn could cause serious

injury or loss of life.

Hose

(2)

a. Connector (16)

Place connector socket in vise as shown

b. Mandrel assem-

Install in connector nipple; tighten nut of

bly

tool connector. Turn tool counterclockwise

to remove connector nipple and nut

c. Hose (2)

Turn hose (2) clockwise out of connector

(16) socket; discard hose

Hose

(2 or

a. Elbow (1, 27,

Place elbow socket in vise. Turn elbow

31)

or30)

counterclockwise to remove nipple and nut

from elbow socket

b. Hose (2 or 31)

Turn hose clockwise out of elbow

socket; discard hose

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and

gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and don't breathe

vapors. Do not use near open flame or excessive heat and don't smoke when using it. Failure to do so

could cause serious injury. If you become dizzy while using cleaning solvent, get fresh air and medical

attention immediately. If contact with skin or clothes is made, flush with large amounts of water. If contact

with eyes is made, wash eyes with water and seek medical aid immediately.

2-661