|
|
TM 9-2320-285-24-1
2-41. TRANSMISSION MAINTENANCE (CONT)
g. Gear Shift Control.
(1) Gear Shift Control Lever and Cable.
STEP
LOCATION
ITEM
ACTION
REMARKS
REMOVAL
1
Transmis-
a. Cotter pin (1)
Remove and
sion, left
discard
hand side
b. Trunnion (2)
Disconnect
Pull from selector lever (6)
c. Nut (4)
Loosen
d. Trunnion (2),
Remove
From cable (27)
adapter (3),
and nut (4)
e. Selector lever
Rotate
Clockwise to last detent
(6)
position, then counter-
clockwise to third detent
position
f. Nut (5)
Loosen
Approximately 1/8 inch
g. Selector lever
Tap
Tap lightly with plastic
(6)
hammer to loosen
CAUTION
In steps lh and li below, do not use mechanical stop inside transmission for removal of nut (5). The
mechanical stop is used for making calibrated adjustment and could be damaged or altered if used
improperly.
h. Selector lever
Hold tightly
(6)
i. Nut (5)
Remove
j. Selector lever
Remove
(6)
2
Left hand
a. Two nuts (7),
Remove
From bracket (13)
transmis-
lock washers
sion mount
(8), U-bolt
(9), shim
(10), and
cable (27)
b. Two capscrews
Remove
(11), lock
washers (12),
and bracket
(13)
3
Left hand
Two tie straps
Cut, remove,
Note locations for installs-
frame rail
(14)
and discard
tion
2-454
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |