|
|
TM 9-2320-285-24-1
2-29.
WATER LEVEL WARNING KIT MAINTENANCE (CONT)
STEP
LOCATION
ITEM
ACTION
REMARKS
ON-VEHICLE TESTING (cont)
WARNING
Be careful when performing the following step not to come in contact with rotating fan. To do so will cause
serious injury. If you are injured by rotating fan, obtain medical aid immediately.
3
Engine,
Hose (5)
a. Clamp
Use two wooden blocks and C-
left side
clamp to block flow of
water to water level
sensor (10). WATER LEVEL
warning light should be lit
and alarm bell should
sound
b. Unclamp
Remove C-clamp and wooden
blocks; WATER LEVEL warn-
ing light should go out
and alarm bell should
stop sounding
4
Tractor cab
Key switch
Place in off
Turns engine off
position
5
Cab tilt
Cab
Tilt 45
pump
degrees
6
Engine,
a. Blue/brown
Disconnect
Cut wire as close to crimp
rear,
wire lead
and tape
connector (2) as possible
water level
b. White wire lead
Disconnect
Cut wire as close to crimp
sensor
connector (1) as possible
c. Multimeter
a. Connect
Across water level sensor
green and red wire leads
b. Observe
Multimeter should indicate
zero ohms. If multimeter
indicates infinity, water
level sensor is defective
and must be replaced
(step 13 below).
7
Cab tilt
Cab
Lower
To normal operating position
pump
8
Tractor cab
Key switch
Place in on
Start engine and operate at
position
idle speed
2-301
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |