|
|
TM 9-2320-285-24-1
2-13.
FUEL SYSTEM MAINTENANCE (CONT)
e. Accelerator and Throttle Linkage (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION (cont)
12
b. Two lock wash-
Install and
On studs welded to cab fire-
(cont)
ers (57) and
tighten
wall
nuts (56)
c. Accelerator
Position
On shaft assembly (60)
lever (42)
d. Washer (55),
Install and
lock washer
tighten
(54), and
locknut (53)
e. Bracket (50)
Position
f. Two lock wash-
Install and
On studs welded to cab fire-
ers (52) and
tighten
wall; secures bracket (50)
nuts (51)
13
Accelerator
a. Nut (45)
Install
On accelerator cable (11);
cable (11)
screw on all the way
against plastic sleeve
b. Rubber boot
Install
On accelerator cable (11);
(44)
connect to cable housing
c. Nut (43)
Install
On accelerator cable (11)
d. Ball joint (41)
Install
On accelerator cable (11) all
the way then back off one
turn or until ball joint
lines up with hole in
accelerator lever (42)
14
Cab side
a. Accelerator
Install
Slide into bracket (50)
cable (11)
b. Clamp (49)
Position
On accelerator cable (11) and
against bracket (50)
c. Capscrew (48),
Install and
lock washer
tighten
(47), and
nut (46)
d. Nut (43)
Tighten
On accelerator cable (11)
e. Ball joint (41)
Install
On accelerator lever (42)
f. Lock washer
Install and
(40) and
tighten
locknut (39)
15
Engine
a. Throttle arm
Install
Refer to TM 9-2815-205-34
governor
(34)
(notify direct support
housing
maintenance)
b. Bracket (18)
Position
2-111
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |