|
|
TM 9-2320-285-24-1
2-12. ENGINE MAINTENANCE (CONT)
e. Dipstick and Tube.
This task covers:
a. Removal
c. Inspection
b. Cleaning
d. Installation
INITIAL SETUP:
Tools
References
No. 1 Common Organizational Maintenance
LO 9-2320-285-12
Tool Kit
(M878A1 Lubrication Order)
Socket wrench set
Adjustable open end wrench
Equipment Condition
Paragraph
Condition Description
Materials/Parts
Cleaning solvent
Item 1, Appendix C
Parked on level surface;
Clean cloths
Item 2, Appendix C
parking brake applied; engine
off.
Personnel Required
Cab tilted 45 degrees.
Wheel Vehicle Mechanic MOS 63B
2-25b
70 ampere circuit breaker and
starter solenoid removed.
2-25a
Starter removed.
STEP
LOCATION
ITEM
ACTION
REMARKS
REMOVAL
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a well
ventilated area. Avoid contact with skin, eyes, and clothes and don't
breathe vapors. Do not use near open flame or excessive heat and don't
smoke when using it. Failure to do so could cause serious injury. If you
become dizzy while using cleaning solvent, get fresh air and medical
attention immediately. If contact with skin or clothes is made, flush with
large amounts of water. If contact with eyes is made, wash eyes with
water and seek medical aid immediately.
1
Engine,
a. Area at bottom
Clean
Use cleaning solvent P-D-680.
rear right
of tube (6)
Prevents intrusion of dirt
side
into engine lubrication
system
b. Nut (2), lock
Remove
washer (3),
and capscrew
(4)
c. Tube clip (5)
Remove
d. Tube (6)
Unscrew
From adapter (7); remove
by withdrawing from bottom
of engine
e. Adapter (7)
Remove
2-58
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |