|
|
TM 9-2320-270-20-3
DATA PLATES SECURED WITH DRIVESCREWS - CONTINUED
ACTION
ITEM
LOCATION
REMARKS
REPLACEMENT
NOTE
Steps in this task are the same for all data plates secured with drivescrews. Winch
control panel engine shut down plate is shown.
Four drive-
1. Data plate (1)
s. Using hammer and chisel, cut off
screws (3)
drivescrew heads.
to winch control
b. Get rid of.
panel(2)
Data plate (1)
Take off.
2. Winch control
panel (2)
3. Winch control
New data plate (1)
Put on as close as possible to
location of old data plate, screw holes
panel (2)
should not line up.
4.
Winch control
a. Put tape on drill twist, same dis-
panel (2)
tance on twist as length of
drivescrew shank.
b. Using new data plate as template and
using drill and twist, drill four holes
same length of screws (3).
Using hammer, tap in.
Four drive-
5. Data plate (1)
screws (3)
to winch control
panel (2)
TASK ENDS HERE
TA240834
4-1326
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |