CONVEX MIRROR HEAD

TM 9-2320-270-20-3

CONVEX MIRROR HEAD

This task covers:

a. Removal (page 4-1228)

b. Installation (page 4-1228)

INITIAL SETUP

Tools

Materials/Parts

Handle, ratchet, 3/8-inch drive

Lockwasher, convex mirror head to bracket

Pliers, slip-joint, straight-nose

Screwdriver, cross-tip, number two

Socket, deep-well, 7/16-inch,

3/8-inch drive

ACTION

ITEM

LOCATION

REMARKS

REMOVAL

NOTE

Steps in this task are the same for both right and left convex mirrors. Right convex mirror

is shown.

If mirror is not holding adjustment, use cross-tip screwdriver and tighten three screws

on back of mirror.

Nut (3) and

a. Using socket and handle, unscrew and

1. Mirror(1) to

Iockwasher (4)

bracket (2)

take off.

b. Get rid of lockwasher (4).

You may have to hold ball shaft

with pliers.

2. Bracket (2)

Mirror (1)

Take out.

Washer (5)

Take off.

3. Mirror (1)

INSTALLATION

Washer (5)

4. New mirror (1)

Put on.

Mirror (1)

Put in place.

5. Bracket (2)

New Iockwasher (4)

Screw on and tighten using socket

6. Mirror (1) to

and nut (3)

and handle.

bracket (2)

4-1228