WIPER AIR LINES

TM 9-2320-270-20-3

WIPER AIR LINES

This task covers:

c. Installation (page 4-1214)

INITIAL SETUP

Materials/Parts

Tools

Loop clamp, air lines and wires to dashboard

Hammer, plastic

(one required)

Handle, ratchet, 1/4-inch drive

Sleeve, air line to fitting (two required

Knife, pocket

per air line)

Pliers, diagonal-cutting

Soap, liquid (item 14, appendix C)

Pliers, long-nose, round

String (item 17, appendix C)

Screwdriver, cross-tip, number 2

Wrap, tie (item 24, appendix C)

Screwdriver, cross-tip, number 3

Socket, 5/16-inch, 1/4-inch drive

Personnel Required

Wrench, open-end, 7/16-inch

Wrench, open-end, 9/16-inch

One

Wrench, open-end, 3/8-inch

ACTION

REMARKS

ITEM

LOCATION

REMOVAL

WARNING

Make sure all pressure is drained from air system before disconnecting air lines. Parts

under pressure can, when removed, fly off with great force causing injury to personnel.

NOTE

Except as noted, steps in this task are the same for all wiper air lines. Air line 36 is

shown.

Chart on next page lists ail six wiper air lines and routing.

Drain (TM 9-2320-270-10).

Air system

4-1208