|
|
TM 9-2320-270-20-3
WINDSHIELD WASHER RUBBER HOSE
This task covers:
a. Removal (page 4-1186)
b. Installation (page 4-1188)
INITIAL SETUP
Personnel Required
Tools
One
Knife, pocket
Pliers, slip-joint, straight-nose
Equipment Condition
Materials/Parts
Left side panel removed (page 4-1104).
Hose, windshield washer (as required)
Tape, pressure sensitive
(item 21, appendix C)
ACTION
ITEM
REMARKS
LOCATION
REMOVAL
WARNING
Make sure all pressure is drained from air system before disconnecting air lines. Parts
under pressure can, when removed, fly off with great force causing injury to personnel.
CAUTION
If hoses have become too brittle to pull off, use pocket knife and cut hose end of fitting
and peel off. Fitting can break if hoses are pulled too hard.
NOTE
Steps in this task are for all four windshield washer hoses. Do only those steps for hose
or hoses that need replacement.
Air system
Drain (TM 9-2320-270-10).
1.
Air line (2)
a. Using pocket knife, cut tape and take
2. Airhose (1)
off.
b. Get rid of.
Fluid hose (3)
a. Using pocket knife, cut tape and take
3.
off.
b. Get rid of.
4-1186
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |