REAR AXLE SPRING LUBRICATION FITTINGS - TM-9-2320-270-20-30159

TM 9-2320-270-20-3

REAR AXLE SPRING LUBRICATION FITTINGS

This task covers:

INITIAL SETUP

Tools

Personnel Required

Wrench, open-end, 7/16-inch

One

ACTION

LOCATION

ITEM

REMARKS

REPLACEMENT

WARNING

When the pusher axle is in the up position, it must be supported by trestles before the perform-

ance of maintenance under the vehicle. Failure to observe this precaution could cause serious

injury to personnel.

NOTE

There are two rear axle spring lubrication fittings. Right fitting is shown. Repeat

procedure for left fitting.

1. Front spring pin (1)

Lubrication

Using 7/16-inch wrench, unscrew and take

fitting (2)

off.

Lubrication

Screw in and tighten, using 7/16-inch

fitting (2)

wrench.

TASK ENDS HERE

TA240680

4-1087