|
|
TM 9-2320-270-20-3
PUSHER AXLE SHOCK ABSORBER
This task covers:
a. Removal (page 4-1084)
b. installation (page 4-1084)
INITIAL SETUP
Personnel Required
Tools
One
Driftpin, brass, 3/8-inch
Hammer, machinist's ball-peen
Hammer, plastic
Handle, ratchet, 3/4-inch drive
Socket, 1 1/8-inch, 3/4-inch drive
Wrench, box-end, 1 1/8-inch
ACTION
REMARKS
ITEM
LOCATION
REMOVAL
NOTE
There are two pusher axle shock absorbers. Left shock absorber is shown. Repeat
procedure for right shock absorber.
1. Shock absorber (1)
Screw (2), two
a.
Using 1 1/8-inch socket, ratchet handle
washers (3), and
with 3/4-inch drive, and 1 1/8-inch
wrench, unscrew and take out.
nut (4)
b.
Using ball-peen hammer and drift, drive
out screw (2).
Screw (5) and
a.
Using 1 1/8-inch socket, ratchet handle
2.
with 3/4-inch drive, and 1 1/8-inch
nut (6)
wrench, unscrew and take out.
b.
Using ball-peen hammer and drift, drive
out screw (5).
Lift off.
Shock absorber (1)
3. Mounting brackets
If necessary, tap with plastic hammer.
(7) and (8)
INSTALLATION
Shock absorber (1)
Using plastic hammer, tap in place.
4. Mounting brackets
(7) and (8)
4-1084
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |