 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM9-2320-270-20-2
TANDEM AXLE HUB, DRUM, AND BEARING ASSEMBLY- CONTINUED
ACTION
REMARKS
ITEM
LOCATION
ASSEMBLY CONTINUED
Put in place.
Slinger (2)
31. Brakedrum (1)
Five screws (3)
Screw in and tighten using 1/2-inch sock-
32. Slinger (2) to
et, extension, and handle.
and washers (4)
brakedrum (1)
INSTALLATION
WARNING
Some parts are heavy. Be careful when handling them. Lifting equipment is needed
when parts weigh over 50 pounds (23 kg) for a single person lift, over 100 pounds
(45 kg) for a two person lift, and over 150 pounds (68 kg) for a three or more person
lift. Do not try to handle heavy parts without lifting equipment. Keep clear of heavy parts
supported only by lifting equipment. Failure to observe this precaution could cause
serious injury or death of personnel.
With help from assistant and using boards
Brakedrum (1)
33. Spindle (5)
and lift truck, slide into place.
and hub (6)
a. Using lubricating gun, coupling,
34. Hub (6)
Outer bearing
bearing packer, and lubricant, pack.
cone (7)
b. Put in.
Screw on until hub (6) turns freely.
Adjusting nut (8)
35. Spindle (5)
Lower lift truck and start rotating
Hub (6)
36.
hub (6).
Using axle nut wrench and wheel nut
37.
Adjusting nut (8)
a.
wrench handle, tighten until hub
(6) starts to bind.
Back off enough to let hub (6) rotate
b.
freely.
Rotate hub (6) to check that it is not
c.
binding or loose.
Put on.
New Iockwasher (9)
38.
Locknut (10)
Screw on and tighten using axle nut wrench
39.
and wheel nut wrench handle.
4-934
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals