FRONT AXLE BRAKE CHAMBER HOSE AND FITTINGS

TM9-2320-270-20-2

FRONT AXLE BRAKE CHAMBER HOSE AND FITTINGS

This task covers:

c. Installation (page 4-655)

b. Inspection/Replacement (page 4-654)

INITIAL SETUP

Materials/Parts

Tools

Lockwasher, nut to bulkhead fitting

Brush, wire

Soap, liquid (item 14, appendix C)

Hammer, plastic

Tag, marking (item 18, appendix C)

Handle, ratchet, 1/2-inch drive

Tape, teflon (item 22, appendix C)

Knife, pocket

Pliers, long-nose, round

Personnel Required

Pliers, slip-joint, straight-nose

Socket, 15/16-inch, deep-well, 1/2-inch

Two

Wrench, open-end, 5/8-inch

Wrench, open-end, 3/4-inch

Wrench, open-end, 7/8-inch

Wrench, open-end, 15/16-inch

Wrench, open-end, 1-inch

ACTION

ITEM

REMARKS

LOCATION

REMOVAL

WARNING

Make sure all pressure is drained from air system before disconnecting air lines. Parts

under pressure can, when removed, fly off with great force causing injury to personnel.

NOTE

Steps in this task apply to left and right front axle brake chamber hose and fittings. Left

hose is shown.

NOTE

Tag lines according to general maintenance instructions (page 4-1).

Drain (TM9-2320-270-10).

Air system

4-653