|
|
TM 9-2320-270-20-2
FRONT AXLE ACTUATOR ASSEMBLY - CONTINUED
INITIAL SETUP CONTINUED
Equipment Condition
Personnel Required
Front axle hub, drum, and bearing assembly
One
removed (page 4-893).
Front axle airbrake chamber removed
Front axle wedge assembly removed
ACTION
REMARKS
ITEM
LOCATION
WARNING
Parts of brake assembly will be coated with asbestos dust. Breathing this dust may be
hazardous to your health. Use a filter mask approved for use against asbestos dust.
Never use compressed air or dry brush to clean these assemblies. Dust shall be
removed using an industrial type vacuum cleaner equipped with a high efficiency filter
system. Clean dirt or mud from brake assemblies with a bristle brush or cloth, and
water.
NOTE
There are two front axle actuator assemblies. This task can be used to replace either
actuator assembly. Right side is shown.
REMOVAL
Using brake repair pliers, take off.
1. Two brakeshoes (1)
Brakeshoe return
spring (2)
TA240402
4-613
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |