|
|
TM 9-2320-270-20-2
FRONT AXLE BRAKESHOES
This task covers:
c. Installation (page 4-611)
a. Removal (page 4-610)
d. Adjustment (page 4-612)
b. Cleaning/Inspection (page 4-611)
INITIAL SETUP
Personnel Required
Tools
One
Hammer, plastic-face
Pliers, brake repair
Equipment Condition
Pliers, slip-joint
Screwdriver, fiat-tip, 1/4-inch
Front axle hub, drum, and bearing assembly
removed (page 4-893).
ACTION
REMARKS
ITEM
LOCATION
WARNING
Parts of brake assembly will be coated with asbestos dust. Breathing this dust maybe
hazardous to your health. Use a filter mask approved for use against asbestos dust.
Never use compressed air or dry brush to clean these assemblies. Dust shall be
removed using an industrial type vacuum cleaner equipped with a high efficiency filter
system. Clean dirt or mud from brake assemblies with a bristle brush or cloth, and
water.
NOTE
There are two sets of front axle brakeshoes. This task can be used to replace either set
of brakeshoes. Right side is shown.
REMOVAL
Using screwdriver, pry off.
Two C-washers (2)
1. Two brakeshoe
and anchor pin
anchor pins (1)
strap (3)
4-610
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |