REMOVAL- CONTINUED - TM-9-2320-270-20-20074

TM 9-2320-270-20-2

INTERAXLE, TRANSFER CASE TO FRONT AXLE AND TANDEM AXLE PROPELLER

SHAFTS - CONTINUED

ACTION

ITEM

REMARKS

LOCATION

REMOVAL- CONTINUED

Tip cross (4) out of transfer case yoke (1)

Transfer case yoke

Sleeve yoke (3)

and pull sleeve yoke (3) off shaft (2).

(1) and splined

shaft (2)

Take off.

Dust cap (5), steel

Splined shaft (2)

washer (6), and cork

washer (7)

Using hammer and punch, bend down four

Two lock plates (9)

Front axle yoke (8)

tabs (10).

Four screws (12) and

Using 9/16-inch socket and handle, un-

Two bearing and cap

screw and take out.

two lock plates (9)

assemblies (11) to

front axle yoke (8)

Using jack and woodblock, push out.

Two bearing and cap

Front axle yoke (8)

It maybe necessary to use pliers to

assemblies (11)

turn and pull out.

Some parts are heavy. Be careful when handling them. Lifting equipment is needed

when parts weigh over 50 pounds (23 kg) for a single person lift, over 100 pounds

(45 kg) for a two person lift, and over 150 pounds (68 kg) for a three or more person

lift. Do not try to handle heavy parts without lifting equipment. Keep clear of heavy parts

supported only by lifting equipment. Failure to observe this precaution could cause

serious injury or death of personnel.

Tip cross (4) out of yoke (8) and take out.

Splined shaft (2)

10.

Front axle yoke (8)

Two lock plates (13)

Using hammer and punch, bend down four

11.

Sleeve yoke (3)

tabs (14).

Four screws (16) and

Using 9/16-inch socket and handle, un-

Two bearing and cap

12.

two lock plates (13)

screw and take out.

assemblies (15) to

sleeve yoke (3)

Two bearing and cap

Using hammer and woodblock, drive out.

Sleeve yoke (3)

13.

assemblies (15)

Tip out.

Cross (6)

14.

Two lock plates (17)

Using hammer and punch, bend down four

Splined shaft (2)

15.

tabs (18).

4-592